# 10.1 Cycle Counting **Category:** [Epicor ERP 10](https://www.epiusers.help/c/e10/5) **Created:** 2016-10-27 15:05 UTC **Views:** 3696 **Replies:** 6 **URL:** https://www.epiusers.help/t/10-1-cycle-counting/35976 --- ## Post #1 by @pjimenez12 is there a way to do cycle counting by bin without having to set up ABC codes? --- ## Post #2 by @bderuvo You can add the parts into the cycle count part selection screen by using the pasting in the screen. I use an excel file with a list of parts. Add a blank column to the left of the part number, only copy and paste the blank filed and the part number. The blank field is a place holder for the Selected column in the screen. --- ## Post #3 by @pjimenez12 so create an excel spread sheet with all parts (we have like 2500) and then copy and paste into this screen? --- ## Post #4 by @bderuvo Exactly. This assumes you have created your cycle count schedule etc. Do you need help with the setup of the schedules? --- ## Post #5 by @pjimenez12 when setting up the cycle count schedules it will not ask me for abc codes? --- ## Post #6 by @bderuvo When creating the Cycle Schedule, do not use Perform Part Selection under actions. --- ## Post #7 by @mschreber The selection mentioned above will do it, but observe that all bins for the part will be printed on the tags, not only the bins used for the selection. --- **Canonical:** https://www.epiusers.help/t/10-1-cycle-counting/35976 **Original content:** https://www.epiusers.help/t/10-1-cycle-counting/35976