4GL code to call an RB report

Yahoo Archive
1
Be careful of using RUNTIME parameters in your filter. My conclusion is
that it makes record selection occur on the PC rather than the server and
your report really bogs down. They way around this is to overwrite the
filter.
-----Original Message-----
From: lonniedrew [mailto:lonniedrew@...]
Sent: Thursday, 7 February 2002 2:57 AM
To: vantage@yahoogroups.com
Subject: [Vantage] Re: 4GL code to call an RB report


Andy,

Check out the source code section in Yahoo Groups "Files". There are
a couple of programs that call the Report Builder engine.

Lonnie

--- In vantage@y..., "Andy Watts" <andy@r...> wrote:
> Hi guys,
>
> Would anyone be prepared to give me a piece of example 4GL code
that will prompt the user for a couple of parameters, then pass these
paramenters to a Report Builder report and run it? I've never used or
even looked at 4GL before, I just need a little kickstart :-)
>
> Thanks in anticipation
>
> ++ Andy Watts
>
> ++ Ripley Engineering Ltd
> ++ Tel: 01256-473940
> ++ Fax: 01256-479991
> ++ mailto: andy@r...



Useful links for the Yahoo!Groups Vantage Board are: ( Note: You must have
already linked your email address to a yahoo id to enable access. )
(1) To access the Files Section of our Yahoo!Group for Report Builder and
Crystal Reports and other 'goodies', please goto:
http://groups.yahoo.com/group/vantage/files/.
(2) To search through old msg's goto:
http://groups.yahoo.com/group/vantage/messages
(3) To view links to Vendors that provide Vantage services goto:
http://groups.yahoo.com/group/vantage/links

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
2
Hi guys,

Would anyone be prepared to give me a piece of example 4GL code that will prompt the user for a couple of parameters, then pass these paramenters to a Report Builder report and run it? I've never used or even looked at 4GL before, I just need a little kickstart :-)

Thanks in anticipation

++ Andy Watts

++ Ripley Engineering Ltd
++ Tel: 01256-473940
++ Fax: 01256-479991
++ mailto: andy@...
3
Andy,

Check out the source code section in Yahoo Groups "Files". There are
a couple of programs that call the Report Builder engine.

Lonnie

--- In vantage@y..., "Andy Watts" <andy@r...> wrote:
> Hi guys,
>
> Would anyone be prepared to give me a piece of example 4GL code
that will prompt the user for a couple of parameters, then pass these
paramenters to a Report Builder report and run it? I've never used or
even looked at 4GL before, I just need a little kickstart :-)
>
> Thanks in anticipation
>
> ++ Andy Watts
>
> ++ Ripley Engineering Ltd
> ++ Tel: 01256-473940
> ++ Fax: 01256-479991
> ++ mailto: andy@r...