701 - new material not showing up in product configurator

Yahoo Archive
1
That was it! I don't remember having to do that in 700C but I'm pretty new to Epicor so maybe I checked them all in and didn't think of the correlation between the two. Thanks!

Jeff Purvis
J&T Distributing
859-745-7956
www.jtfoc.com


----- Original Message -----
From: jckinneman
To: vantage@yahoogroups.com
Sent: Friday, December 14, 2012 4:34 PM
Subject: [Vantage] Re: 701 - new material not showing up in product configurator



Part all checked in after the changes in Engineering workbench?

Jim Kinneman
Encompass Solutions, Inc

--- In vantage@yahoogroups.com, "jeff" <jeff.purvis@...> wrote:
>
> We just installed 701 and then added a new material to a part in the engineering workbench. We then opened the product configurator and the new material is not showing up under the method rules. We can only see the materials that were added in 700C. Has anyone had this problem yet and figured out what was happening?
>





[Non-text portions of this message have been removed]
2
We just installed 701 and then added a new material to a part in the engineering workbench. We then opened the product configurator and the new material is not showing up under the method rules. We can only see the materials that were added in 700C. Has anyone had this problem yet and figured out what was happening?
3
Part all checked in after the changes in Engineering workbench?

Jim Kinneman
Encompass Solutions, Inc

--- In vantage@yahoogroups.com, "jeff" <jeff.purvis@...> wrote:
>
> We just installed 701 and then added a new material to a part in the engineering workbench. We then opened the product configurator and the new material is not showing up under the method rules. We can only see the materials that were added in 700C. Has anyone had this problem yet and figured out what was happening?
>