Hello, I am fairly new to Epicor. I understand the basics, but I’ve been looking around the internet for a while and cannot figure out why I am so stumped on adding / editing search parameters in a Kinetic Dashboard in Application Studio. I have converted a classic into kinetic dashboard, and I see a couple of the same search parameters, but not everything. I tried looking around Application Studio to see how these search parameters are connected to the data so I know where to edit them and even create a new search parameter, I would think there would need to be an event but there doesn’t seem to be for the search params that are there. I cannot find any forum or video to help explain it to me, which is why I think this might be a stupid question because I might be missing something that’s right in front of my face. Would anyone have any suggestions on where I can learn more about this? Anything is helpful, thank you.
I figured it out. If anyone was wondering how to set it up and understand how to set up searching with parameters, look at this - (Use textbox to filter a baq, kinetic dashboard - #6 by aidenhoffman)
1 Like