Bug

yes, this is a bug. It will not be fixed in the 307 patch. It seems like a
serious enough bug to get priority, but not according to development.

Regards,

Darren Mann

> -----Original Message-----
> From: Jeanne Weiler [mailto:JWEILER@...]
> Sent: Friday, February 02, 2001 9:37 AM
> To: vantage@yahoogroups.com
> Subject: [Vantage] bug
>
>
> My EE has just emailed the following "bug" with Vantage 5.0.
> This occurs on
> all stations that have this program. It did not occur with 3.0 Does
> anyone have a similar problem and if so what has anyone done
> to correct it.
>
>
> I have found that my ACCEL EDA
> schematic and
> PCB tools will not launch properly when Vantage is running on
> my computer.
> My ACCEL tools will lock up until Vantage is closed. After Vantage is
> closed, my programs will operate normally.
>
>
>
> ------------------------ Yahoo! Groups Sponsor
> ---------------------~-~>
> eGroups is now Yahoo! Groups
> Click here for more details
> http://click.egroups.com/1/11231/1/_/411782/_/981128631/
> --------------------------------------------------------------
> -------_->
>
> To unsubscribe from this group, send an email to:
> vantage-unsubscribe@egroups.com
>
>
>
>
My EE has just emailed the following "bug" with Vantage 5.0. This occurs on
all stations that have this program. It did not occur with 3.0 Does
anyone have a similar problem and if so what has anyone done to correct it.


I have found that my ACCEL EDA schematic and
PCB tools will not launch properly when Vantage is running on my computer.
My ACCEL tools will lock up until Vantage is closed. After Vantage is
closed, my programs will operate normally.