Crystal version 8.0 sub reports shared variables and condition

http://support.crystaldecisions.com/kbase/c2005853.asp?AJID=7B4FC1CB159CC2428820C4B8328BC5A1

This article describes a couple ways to supress subreports. Maybe one of them will work for you.

Troy Funte
Liberty Electronics

----- Original Message -----
From: Dan Shallbetter
To: vantage@yahoogroups.com
Sent: Monday, July 16, 2001 5:31 PM
Subject: [Vantage] Crystal version 8.0 sub reports shared variables and conditional ly suppression



I am trying to create a pick list that will print a certificate of
compliance (C.O.C.) based on a VB check box on the part. I've created an
O.D.B.C sub report consisting of the part table, that contains the C.O.C
wording . I have link the sub report to the canned Vantage Sopickl.rpt I
pass the orddetail.partnumber to the sub report as an unlinked parameter
field. I created a shared variable formula in the sub report comparing the
orderdetail.part number to part.part number. I want to use the shared
variable to conditionally suppress the section containing the sub report,
but as I understand it passing the shared variable back to the main report
has to occur in section below the sub report (Crystal K.B c2007600), This
one is driving me CRAZY, any help would be greatly appreciated.

Thanks
Dan Shallbetter
States Electric Mfg.




To access the Files Section of our Yahoo!Group for Report Builder and Crystal Reports and other 'goodies', please go to: http://groups.yahoo.com/group/vantage/files/. Note: You must have already linked your email address to a yahoo id to enable access.

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.



[Non-text portions of this message have been removed]
I am trying to create a pick list that will print a certificate of
compliance (C.O.C.) based on a VB check box on the part. I've created an
O.D.B.C sub report consisting of the part table, that contains the C.O.C
wording . I have link the sub report to the canned Vantage Sopickl.rpt I
pass the orddetail.partnumber to the sub report as an unlinked parameter
field. I created a shared variable formula in the sub report comparing the
orderdetail.part number to part.part number. I want to use the shared
variable to conditionally suppress the section containing the sub report,
but as I understand it passing the shared variable back to the main report
has to occur in section below the sub report (Crystal K.B c2007600), This
one is driving me CRAZY, any help would be greatly appreciated.

Thanks
Dan Shallbetter
States Electric Mfg.