Thanks! This should work great!
--- In vantage@yahoogroups.com, "Richard Bailey" <rbailey@...> wrote:
>
> Jasper,
> Our macro doesn't successfully close out of Vantage following the
completion
> of our daily MRP run but it does end the process OK and return to
the
> Vantage menu. No big deal, it just means that a Vantage session is
left
> running on my PC until I arrive the next morning. The commands I
use to exit
> the GC macro are:
> // When Processing Finishes End Macro
> While(Not(WindowActive("Information")))
> Delay(60000)
> EndWhile
> Delay(500)
> SendKeys("{ENTER}")
> Delay(10)
> ExitMacro()
> // End Of Routine
>
> HTH
> Regards,
> Richard
>
> Richard Bailey
> Dudley Industries
> Mailto: rbailey@...
> Tel: +44(0)1253 738311
> Mob: +44(0)7836 550360
> Fax: +44(0)870 7628173
>
> -----Original Message-----
> From: vantage@yahoogroups.com [mailto:vantage@yahoogroups.com]On
Behalf
> Of Jasper Recto
> Sent: 09 May 2006 21:51
> To: Vantage Groups (E-mail)
> Subject: [Vantage] Ground Control to automate MRP Regeneration
>
>
> For those who are using Ground control to automate MRP, how did you
write
> your script to close Vantage once the MRP process is done AND how
did you
> know when to close it?
>
> Thanks,
> Jasper
>
>
>
> [Non-text portions of this message have been removed]
>
>
>
>
> Useful links for the Yahoo!Groups Vantage Board are: ( Note: You
must have
> already linked your email address to a yahoo id to enable access. )
> (1) To access the Files Section of our Yahoo!Group for Report
Builder and
> Crystal Reports and other 'goodies', please goto:
> http://groups.yahoo.com/group/vantage/files/.
> (2) To search through old msg's goto:
> http://groups.yahoo.com/group/vantage/messages
> (3) To view links to Vendors that provide Vantage services goto:
> http://groups.yahoo.com/group/vantage/links
> Yahoo! Groups Links
>