Howdy,
Try turning off bi-directional support in the w2k workstation's printer
configuration.
might help.
Charles
Try turning off bi-directional support in the w2k workstation's printer
configuration.
might help.
Charles
----- Original Message -----
From: "Norm Watkins" <nwatkins@...>
To: "Vantage@Yahoogroups. Com" <vantage@yahoogroups.com>
Sent: Monday, September 19, 2005 12:15 PM
Subject: [Vantage]OT AutoCAD print problems
> I hate to bother the Vantage group with this problem, but the
ACAD/Autodesk
> forums/user groups have not responded to my problem.
>
> I have AutoCAD 2002 on a W2000 workstation, and when I try to print to a
> shared HP-1220C Inkjet printer I get the following error: "Data area sent
to
> a system call is too small", and nothing prints. Printing the same file
> from a W98 Workstation/ACAD 2000i works fine. It just started happening,
> but I can't figure out what I might have installed that messed up the
> printing.
>
> Any ideas from anyone?
>
> Norm Watkins
> Engineering Manager
> ELECPAC
> Phone: 847-639-2307
>
>
>
>
> Useful links for the Yahoo!Groups Vantage Board are: ( Note: You must
have already linked your email address to a yahoo id to enable access. )
> (1) To access the Files Section of our Yahoo!Group for Report Builder and
Crystal Reports and other 'goodies', please goto:
http://groups.yahoo.com/group/vantage/files/.
> (2) To search through old msg's goto:
http://groups.yahoo.com/group/vantage/messages
> (3) To view links to Vendors that provide Vantage services goto:
http://groups.yahoo.com/group/vantage/links
> Yahoo! Groups Links
>
>
>
>
>
>
>
>