Removing "issued complete" status

Oops.. forgot to change the subject line....


All,

I hope someone can tell me of a workaround for this one. I was assured by
Epicor's support that this issue has been dealt in the latest patch (116),
but I am still fighting it.

When we fulfill the requirements of a (purchased) part on an assembly, the
line item is marked complete. However, invariably parts issued on one
machine sometimes get taken off of the machine they were issued on and used
on another project where they are more urgently needed. In Vantage, the
part gets un-issued from one job and issued to the other. Here is the
problem, though; on the original assembly the part line still shows the part
as issued complete. Does anyone know where I can change this status
manually?

TIA,

Paul


Useful links for the Yahoo!Groups Vantage Board are: ( Note: You must have
already linked your email address to a yahoo id to enable access. )
(1) To access the Files Section of our Yahoo!Group for Report Builder and
Crystal Reports and other 'goodies', please goto:
http://groups.yahoo.com/group/vantage/files/.
(2) To search through old msg's goto:
http://groups.yahoo.com/group/vantage/messages
(3) To view links to Vendors that provide Vantage services goto:
http://groups.yahoo.com/group/vantage/links

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/