I posted the same message about 2 weeks ago. Vantage does not handle
this well. If you would like, call me and I will explain how we are
handling this.
I am only in the office until 3:30. (eastern time)
Dina Hieber
Vamco International, Inc.
(412) 963-7100
singlefire2001 wrote:
Dina M. Hieber
Vamco International, Inc.
555 Epsilon Drive
Pittsburgh, PA 15238
(412) 963-7100 - phone
(412) 963-9511 - fax
www.vamcointernational.com
[Non-text portions of this message have been removed]
this well. If you would like, call me and I will explain how we are
handling this.
I am only in the office until 3:30. (eastern time)
Dina Hieber
Vamco International, Inc.
(412) 963-7100
singlefire2001 wrote:
> I have a few parts that are either manufactured or purchased and are--
> used in assemblies on a "1-per" basis. The parts (2) are sent to a
> welder and assembled into a finished part. The part number is
> different than the components (obviously). Does Vantage hide a quick
> trick to be able to send these components to the welder and recieve
> them back as the finished part number without losing traceability of
> the components or the finished part? The problem lies in getting the
> materials both finished and sub-level to adjust their inventories
> without doing it manually.
>
>
>
>
> Useful links for the Yahoo!Groups Vantage Board are: ( Note: You must
> have already linked your email address to a yahoo id to enable access.
> )
> (1) To access the Files Section of our Yahoo!Group for Report Builder
> and Crystal Reports and other 'goodies', please goto:
> http://groups.yahoo.com/group/vantage/files/.
> (2) To search through old msg's goto:
> http://groups.yahoo.com/group/vantage/messages
> (3) To view links to Vendors that provide Vantage services goto:
> http://groups.yahoo.com/group/vantage/links
>
> Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
Dina M. Hieber
Vamco International, Inc.
555 Epsilon Drive
Pittsburgh, PA 15238
(412) 963-7100 - phone
(412) 963-9511 - fax
www.vamcointernational.com
[Non-text portions of this message have been removed]