# V10 BPM Data Directive Send Email Not Working

**Category:** [Epicor ERP 10](https://www.epiusers.help/c/e10/5)
**Created:** 2016-10-07 16:47 UTC
**Views:** 1539
**Replies:** 1
**URL:** https://www.epiusers.help/t/v10-bpm-data-directive-send-email-not-working/35741

---

## Post #1 by @DaveOlender

We are running V10.1.400.18 
I am trying to update a BPM Data Directive (Standard - Not InTransaction) on the PartWhse table.  
In V9 we have the condition set to look for ttPartWhse.Onhand < 0 then send an email based on epicor stardard email action.

In V10 I am unable to "Validate".  I get an error message that says "ttPartWhse" is Non-Existent.

I tried rewriting the BPM to use PartQty table instead and I get the same error message.

Anyone run across this yet.

DaveO

---

## Post #2 by @DaveOlender

Got it to work.  The trick is to ignore the "Validate" function in the Condition Block. 
I saved the BPM (with my updated query) and it saved without error.  So I tested it and the email comes through fine.

So - note to self - BPM Data Directive Standard - Don't freak out if the Validate function throws errors.  Forge on - save the BMP and test.

DaveO

---


**Canonical:** https://www.epiusers.help/t/v10-bpm-data-directive-send-email-not-working/35741
**Original content:** https://www.epiusers.help/t/v10-bpm-data-directive-send-email-not-working/35741