END Activity Non-existing job

Yahoo Archive
1
Yes,I am able to end the activity now.
Thank you ALL
2
One of my shop employee entered Job ID as 0(zero)by mistake and hit enter,everything got frozen.
We cannot end activity or clock him out.
If I click end activity I get an error msg "A valid job no is required"
Please advise.
I have Vantage 6.10

Thank you All
3
Go into System Management / Utilities / Data Conversion & run #7428 to end the activity....
That should do the trick.

Julie
Mercury Minnesota Inc.

----- Original Message -----
From: zuhaib_akhtar
To: vantage@yahoogroups.com
Sent: Tuesday, November 17, 2009 12:53 PM
Subject: [Vantage] END Activity Non-existing job



One of my shop employee entered Job ID as 0(zero)by mistake and hit enter,everything got frozen.
We cannot end activity or clock him out.
If I click end activity I get an error msg "A valid job no is required"
Please advise.
I have Vantage 6.10

Thank you All





[Non-text portions of this message have been removed]
4
I am sorry I just check it shows the job number is empty but assembly is 0(zero).
I tried running #7428 data collection ....Nothing happened after I ran.
Please Advise.
Thank you
5
Did you do a "Conversion / Run the Conversion Program"? Were you able to get to the point to enter the employee # and get the details of his/her job?
It should pull that up for you and then you have the option to change the "yes" to "no" under "Active".
Hope that helps.
Julie
Mercury Minnesota Inc.


----- Original Message -----
From: zuhaib_akhtar
To: vantage@yahoogroups.com
Sent: Tuesday, November 17, 2009 2:05 PM
Subject: [Vantage] Re: END Activity Non-existing job



I am sorry I just check it shows the job number is empty but assembly is 0(zero).
I tried running #7428 data collection ....Nothing happened after I ran.
Please Advise.
Thank you





[Non-text portions of this message have been removed]