Automatic Clock Out from Data Collection?

Our supervisors, using shop tracker, monitor "who is here" in the system but not really here and then clock them out. This gives them first hand knowledge of who to chew out the next day. They also send a labor edit card up to the office for adjustment the next morning. By keeping the supervisor (and their wrath) in the loop the frequency of forgetting is much reduced.

-Todd C.

-----Original Message-----
From: aslep1 [mailto:annas@...]
Sent: Tuesday, February 03, 2004 1:04 PM
To: vantage@yahoogroups.com
Subject: [Vantage] Automatic Clock Out from Data Collection?


Is there anyway to have Vantage automatically clock out employees in
Data Collection?

The problem that we have found is some employees will end their
activity. but forget to clock out. This in turn creates a problem
for editing labor.

Is there any solution to this problem?

Is there a good work around?



Useful links for the Yahoo!Groups Vantage Board are: ( Note: You must have already linked your email address to a yahoo id to enable access. )
(1) To access the Files Section of our Yahoo!Group for Report Builder and Crystal Reports and other 'goodies', please goto: http://groups.yahoo.com/group/vantage/files/.
(2) To search through old msg's goto: http://groups.yahoo.com/group/vantage/messages
(3) To view links to Vendors that provide Vantage services goto: http://groups.yahoo.com/group/vantage/links



_____

Yahoo! Groups Links


* To visit your group on the web, go to:
http://groups.yahoo.com/group/vantage/


* To unsubscribe from this group, send an email to:
vantage-unsubscribe@yahoogroups.com <mailto:vantage-unsubscribe@yahoogroups.com?subject=Unsubscribe>


* Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service <http://docs.yahoo.com/info/terms/> .




[Non-text portions of this message have been removed]
Is there anyway to have Vantage automatically clock out employees in
Data Collection?

The problem that we have found is some employees will end their
activity. but forget to clock out. This in turn creates a problem
for editing labor.

Is there any solution to this problem?

Is there a good work around?