Part router and job scheduling in Vantage

Every time I have seen this message it is because the resource group
tied to the operation does not have at least one resource.

The training database has had this problem in the past.



Hope this helps.



Dale E. Schuerman



________________________________

From: vantage@yahoogroups.com [mailto:vantage@yahoogroups.com] On Behalf
Of Tri Ha
Sent: Tuesday, February 27, 2007 12:39 PM
To: vantage@yahoogroups.com
Cc: Quang Le; Binh L Nguyen
Subject: [Vantage] Part router and job scheduling in Vantage



Hi all,

We hit problems at the vantage user-end. My users were unable to
schedule the job with the error message "Each job operation must have at
least one Resource or Resource Group defined as Location, or a
Capability which Primary Resource Group is defined as Location."

Another problem also related to job scheduling since the part were
missing operation's resources. As a result, vantage didn't let us print
out the traveler and further enter labor entry or track location of the
part.

Please advice if any one got the same problems.

Thanks

[Non-text portions of this message have been removed]




########################################################################
Attention:
This email message is privileged and confidential. If you are not the
intended recipient please delete the message and notify the sender.
Any views or opinions presented are solely those of the author.

This email message has been scanned for Viruses and Content and cleared
by MailMarshal SMTP

For more information go to http://www.ramsys.com
########################################################################


[Non-text portions of this message have been removed]
Hi all,

We hit problems at the vantage user-end. My users were unable to
schedule the job with the error message "Each job operation must have at
least one Resource or Resource Group defined as Location, or a
Capability which Primary Resource Group is defined as Location."

Another problem also related to job scheduling since the part were
missing operation's resources. As a result, vantage didn't let us print
out the traveler and further enter labor entry or track location of the
part.

Please advice if any one got the same problems.



Thanks





[Non-text portions of this message have been removed]