I am looking for information on the Bill of Materials and cost roll up. We have an issue and I know very little and currently have little info to help me even know where to start.

Check if your OnLine help includes the Print Version [image]

@Will79 Sorry I couldn’t get back with you sooner. The “Total Cost” is how much the system thinks your total cost should be for this part. The “Part Cost” is what the Standard Cost is set to right now. Did the cost of the material decrease? If the cost of the material hasn’t decreased since the …

May not be particularly related to your issue but for reference: Make sure the component purchase part does not have a method. Epicor will roll up the part even if it’s coded as purchase part unless you specifically tell it to not roll up purchase parts under “Site Cost Maintenance” [image] A…

@Beth Those were the same question’s I’ve been asking. The only change I’ve been able to see was that when the parent part is cut into sheets for this part the standard is 600 parts per roll/ However, sometimes it’s way more like 700. So I have been wondering if these numbers aren’t reflecting in…

@Will79 If you are looking at actuals, then yes, you would see a difference with the parts per roll but a cost roll doesn’t look at actual jobs. It looks at how the current method of manufacture is set up. So if the method has only 600 parts per roll and the method used to do the cost roll the pre…

Remember when you did the DMT to change the BOM to the actuals? That will change the costs. [image] DMT Qty/Parent Change ERP 10 I am updating the BOM.

@Beth I haven’t done the roll up yet, but I see your point. I’ve looked in the engineering and everywhere everyone has mentioned, everything looks right. It’s set to 600, in the engineering the only thing that’s going on is the pieces per hours and the setup costs. But those figure into labor, ri…

@Will79 Yes, those costs figure into labor. Material costs are how much of the material are you using to produce the part and what is the cost for that piece: (Full sheet / number of pieces) * cost of full sheet = cost of material for part The only other thing I can think of that would change the …

@Beth It was changed twice since the last roll up. Well, before I was playing around with it. LOL! Anyway, using your formula above, the number of sheets is what is variable. In a perfect world we would get exactly a 150 foot roll to sheet. But sometimes we got more, other times less. So that …

@Will79 Isn’t costing fun!!! [mad scientist image]

Information on the Bill of Materials and cost roll up

Epicor ERP 10

Banderson (Brandon Anderson) October 3, 2017, 12:39pm 37

Remember when you did the DMT to change the BOM to the actuals? That will change the costs.

Topic		Replies	Views
Part Costs Epicor ERP 10 e10	86	17088	April 4, 2019
Costing workbench selection help Epicor ERP 10	10	9791	November 17, 2017
Cost rollup and BOM Epicor ERP 10 epicor	15	1144	May 21, 2024
BASIC QUESTION: How get cost of manufactured part? Epicor ERP 10 costing , part-cost	27	4780	April 21, 2022
Standard Cost Epicor ERP 10 costing	28	10351	May 10, 2021

Information on the Bill of Materials and cost roll up

Related topics